Specifications

9.12 Board, DC Control
9.12.1 Page Count Memory (NVRAM)
Use the following procedure to remove the video controller board.
Caution: Use standard antistatic equipment and procedures before you handle
this sensitive electronic component.
1. If installed, remove the hard disk option, as shown in Section 9.6.
2. Remove the video controller board as shown in Section 9.15.
3. Use a suitable tool to gently pry up the 8-pin IC.
4. Remove the IC.
When replacing the IC, make sure to orientate pin 1 is as shown.
DSG-000659
9–32 Removing and Replacing FRUs