Specifications

9.5 Assembly, Low-Voltage Power Supply (LVPSA)
9.5 Assembly, Low-Voltage Power Supply (LVPSA)
Use the following procedure to remove the low-voltage power supply assembly
(LVPSA):
1. Remove the right-side cover, as shown in Section 9.19.
2. Remove the three screws that hold the metal panel to the printer.
3. Remove the metal panel.
When you replace the metal panel and tighten the three screws, make sure
the linkage for the power switch is not pinched and that the action of
the power switch is smooth and positive.
1
DSG-000635
9–8 Removing and Replacing FRUs