Specifications

9.4 Assembly, High-Voltage Power Supply (HVPSA)

Use the following procedure to remove the high-voltage power supply assembly

(HVPSA):

1. If installed, remove the optional LCIT, as shown in Section 9.10.

2. Remove the EP-ED cartridge, as shown in Section 9.17.

3. Stand the printer up on the right-side cover.

4. Remove the two screws.

5. Release the two clips while wiggling the HVPSA.

6. Carefully withdraw the HVPSA.

Caution Do not damage the contact springs and connectors.

DSG-000640

Removing and Replacing FRUs 9–7