Specifications

9.2 Assembly, Control panel

Use the following procedure to remove the control panel Assembly:

1. Remove the paper cassettes.

2. Remove the right-side and top covers, as shown in Section 9.19 and

Section 9.20.

3. Remove the three screws that hold the metal panel to the printer.

4. Remove the metal panel.

When you replace the metal panel and tighten the three screws, make sure

the linkage for the power switch is not pinched and that the action of

the power switch is smooth and positive.

DSG-000635

9–2 Removing and Replacing FRUs