Specifications

7.3 Paper Feed Area Jams

This section covers jams, skewing, or feed failure caused by a malfunction in

the front or feed area of the DEClaser 5100 printer.

1. If the jamming occurs in the fusing or delivery areas, go to Section 7.4.

2. Try some fresh paper or envelopes of known good quality.

3. Make sure the tray, cassette, or envelope feeder is loaded, but not

overloaded, and is adjusted properly.

4. Thoroughly inspect the following for damage or malfunction. If you see any

broken or cracked plastic, replace the damaged components.

• The LCIT and internal cassettes

• The envelope feeder

• The EP-ED cartridge

• The paper path guides, registration sensor linkage, jam plate.

5. Feed paper from all available inputs. Note the feeder that causes the

jam and the type of jam..

6. Table 7–3 lists the originating feeder (vertically) and the types of jams

(horizontally). Use this table to ﬁnd the FRU swap list. Swap the FRUs

until the jam is ﬁxed.

Before swapping a FRU, make sure it is installed properly and look for

loose connectors or screws.

7–4 FIPs for Fixing Paper Jams