Setup guide

2.3.1.2 When the Printer is Between Devices on the Network
This procedure describes how to connect the printer when it is installed
between devices on an existing network. Figure 2–2 shows the network
configuration before, and after the printer is installed.
NOTE
Installing the DEClaser 5100 printer between devices interrupts
network operation until the new connections are made. You should
notify users on the network before connecting your printer so they are
aware of the temporary interruption.
1. Connect the short cable from the new connector box to the LocalTalk port
on the back of the printer .
2. Unplug the network cable from an existing connector box and connect it to
the new connector box .
3. Connect one end of the new network cable to the new connector box and
the other end to the existing connector box .
2–14 Connecting the Printer and Installing Drivers