Setup guide

1.7 Performing the Printer Self-Test
To verify the printer is operating properly before connecting it to your
computer, press the power switch to the | (ON) position.
The indicator lights on the control panel flash momentarily, and after
the printer warms up (approximately 40 seconds) it generates a start-up
page, listing items such as communication settings and installed options
(Figure 1–3).
Go to Chapter 10 in your DEClaser 5100 Printer User’s Guide if the printer
does not power on correctly.
If you have additional options, such as SIMMs, a network interface card or
a disk drive, you should power off the printer and install them at this time.
Figure 1–3 Example of the Start-Up Test Page
POSTSCRIPT
®
D
E
C
l
a
s
e
r
5
1
0
0
Adobe PostScript™ Level 2
with DECimage™ enhancement
HP-PCL™ Level 5E emulation


Large-capacity input tray installed
Network interface card installed
Hard disk installed
High resolution card installed
PostScript version
PostScript revision

RAM size

Serial communications port
interpreter
baud rate

Parallel communications port
interpreter
baud rate

LocalTalk communications port
interpreter
mode

Network communications port
interpreter
2013.109
12

6.0 MB


PostScript
9600


AutoSelect
Centronics


PostScript



PostScript
Office printer #4
Courier
The Digital logo is a trademark of Digital Equipment Corporation Page design copyright 1991, 1993 Digital Equipment Corporation.
199999
DSG-000578
™
pDYW
Tekton
Parisian
Formata
Barmeno
Kaufmann
Lithos
Park Avenue
Americana
Trajan
ITC Souvenir
ITC Bookman
Adobe Caslon
ITC Zapf Chancery
ITC Lubalin Graph
Adobe Garamond
Blackoak
ITC Avant Garde Gothic
New Century Schoolbook
Times
Helvetica
Palatino
Helvetica-Narrow
This completes the testing section of the installation. Go to Chapter 2 to
continue the installation.
Installing the Printer 1–13