Setup guide

Installation and service tips
Important step when removing packing material
Section 1.3 of the Installation and Setup Guide describes the steps for removing
the packing material as part of the installation procedure. You must remember
to perform step 9 of this procedure while removing the packing material from
the printer.
In this step, you must push down the fusing assembly levers on each side of
the fusing unit as shown on the diagram on the card stock inside the rear door
of your printer. A figure indicating the location of the fusing assembly levers is
also given in Section 1.3 of the Installation and Setup Guide.
Failure to push down these levers during installation prevents your
printer from properly fusing toner to the paper. As a result, the toner
does not bind to the paper and can be rubbed off.
Locating your printer’s firmware version number
You may need to provide the firmware version of your printer if you contact
Digital Customer Services about your printer. Several version numbers,
referring to portions of the printer firmware, can be found on the test pages.
The overall printer firmware version number is printed on the PCL Menu
Settings page, just beneath the words ‘‘DEClaser 5100.’’ (Refer to Figure 2-4 in
the User’s Guide.)
If your printer has the DEClaser 5000 Series Ethernet Card installed, its
status page is printed when you turn on your printer. The firmware version of
your Ethernet card is located in the upper right corner of that page.
Turning off the Startup Test Page
The first time you power on your printer, a Startup Test Page prints to confirm
that your printer is operating properly. This test page prints every time
you power on your printer unless you disable this feature. You can turn off
automatic printing of the Startup Test Page as follows:
1. Press
On Line
to pause the printer.
2. Press
Set-Up
to enter the Set-Up menu.
3. Use and to choose the Miscellaneous sub-menu.
4. Press to choose the Do start page feature.
5. Press again to display the current setting: START PAGE=yes.
6. Press to change the display to START PAGE=no.
1