Technical data

5.12 0702 ADD PAPER TO TRAY 2
3. Inspect the following for damage, misconnection, or mechanical failure:
• Operation of the cassette elevator
• Lower paper out sensor mounting
• Lower paper out sensor linkage
• 2-pin plug that connects to the lower paper out sensor
• 4-pin plug that connects to P/J44 (see Figure 5–11) on the DC control
board. Pin three of P/J44 goes high when the sensor is actuated.
4. Swap the following:
1. DC control board
2. Lower paper out sensor
3. Lower cassette-size sensor assembly
5.13 0703 ADD PAPER TO FEEDER
Description: This error message is displayed when the LCIT paper out sensor
finds that the LCIT is empty. Many LCIT malfunctions can cause this error.
Troubleshooting: Before performing the following FIP, make sure the printer
is in good working order. Select a cassette and feed test prints from it.
1. Make sure the LCIT is plugged into the printer and the lead-in cable is in
good condition.
2. Run the elevator down to check the operation of the LCIT. If this test fails,
go to Chapter 11 to diagnose the LCIT.
3. Test the operation of the paper out sensor linkage, sensor/switch, and
circuit. Open the LCIT door and manually move the sensor linkage up and
down while watching the control panel for the following:
• Linkage up = error message clears
• Linkage down = error message appears
• If the sensor linkage is stiff or fails to move, remove the LCIT front
and rear side covers and fix.
• The test fails if the control panel does not change.
5–20 Display Error Code FIPs