Technical data

3.3 Test Print Menu
When the printer is printing, press
Test
to step through the following
informational displays. This information is also available through the 1701
special function codes, as shown in Table 3–1.
• J = Number of test prints since start of job
• S = Number of prints since power on
• L = Number of prints on this printer (Life count)
• X = Number of prints remaining on print drum
• D = Number of prints remaining on developer cartridge
• T = Number of prints remaining on developer cartridge
Press to start or stop the continuous feeding print job.
Press
Test
to step through the C W B test prints. Figure 3–4, shows
examples of the three test patterns.
Press
Defaults
to change to the following feed device:
• 1 = Upper cassette
• 2 = Lower cassette
• 3 = LCIT feeding
• 4 = Manual feeding slot. Before manual feeding, you must set the
sheet size by using the special function test code 0281.10, as shown in
Table 3–1.
Press the
Online/Pause
to toggle the offset motor on and off for test
printing. The N and F characters stand for no-offset or offset.
Press
Set Up
to toggle between simplex or duplex paper paths for test
printing. The S or D characters identify the selected paper path.
Service Menus and Tests 3–13