Technical data

3.1 1701 Special Function and Test Codes
Table 3–2 (Cont.) 1701 Test Codes
Test
Code
Display or
Prompt Definition
0400.05 PASS The main motor, transfer, and charger
1
run.
0400.06 PASS The main motor, developer bias, and main charger
1
run.
0400.07 PASS The main motor and all HVPSA outputs
1
run.
0610 PASS The scanner motor runs.
0710 SENSING Manual bypass sensor.
0711 data Displays size of upper cassette.
0712 data Displays size of lower cassette.
0721 SENSING Upper cassette empty sensor.
0722 SENSING Lower cassette empty sensor.
0790 SENSING Continuous beeper and all control panel indicators.
0801 Clicks Upper feed solenoid.
0802 Clicks Lower feed solenoid.
0803 Complete Runs the LCIT paper feed motor if the LCIT is connected
and loaded with paper. The INVALID message is displayed
if the LCIT is not attached.
0804 Clicks Refeed clutch.
0805 Clicks Registration clutch.
0810 SENSING Registration sensor.
0811 SENSING Gate sensor.
0812 SENSING Exit sensor.
0813 SENSING Refeed sensor.
0814 SENSING Output tray full sensor.
0815 SENSING Offset home position sensor.
0851 Clicks Upper turn roller clutch.
0852 Clicks Lower turn roller clutch.
1
The motor is tested, the charger is just turned on.
Note: When you see the SENSING prompt, you must manually actuate the sensor under test.
You may need the interlock cheating tool for covers open operation. The tool is part of the
miscellaneous parts kit, shown in Table 8–1.
(continued on next page)
3–6 Service Menus and Tests