Technical data

2.2 Operational Display Format
Table 2–2 (Cont.) Printer Status Messages
Status Message Meaning
POWER SAVER ON This message is displayed after the printer has been idle
for a period of time. The factory default is 2 hours but the
interval can be set to 0–2.7 hours, in 15 minute increments,
through the 1701 special functions code 0282.90. See
Table 3–1. When the message is displayed, the fusing
unit heater is turned off, thus saving power.
The printer exits the Power Saver Mode when printer
receives a print job from the host or from the control panel,
or if any printer cover is opened and then closed.
WAITING
2
The print job context is active, but there is no data to
process.
WAIT FOR PAUSED
2
Informs the operator that the control panel function
requested cannot be performed because a PostScript
job is currently being processed (PostScript operator
‘‘allowjobreset’’ is true).
PRESS TO ABORT
2
Instructs the operator to press to abort the current print
job (PostScript operator ‘‘allowjobreset’’ is false).
INITIALIZING PS
2
Displayed when the PostScript protocol is selected but the
printer is not ready to accept data from the host.
TEST PRINT PS
2
This message is displayed for about 45 seconds while the
PostScript startup page is building.
2
This message is displayed only when the PostScript protocol is selected.
2.3 About the Customer and Service Menus
The following customer and service menus are available within the DEClaser
3200 printer. Customer menus are accessible through a single stroke of a
control panel key. To access a service menu, a special code or procedure is
required which is not published in the DEClaser 3200 Printer Operator’s
Guide.
Customer Menus Service Menus
Section 2.4, Set Up Menus Section 3.3, Test Print Menu
Section 2.5, Defaults Menu Section 3.2, 1948 Service Menu
Section 2.6, Test Menu Section 3.1, 1701 Special Function and Test Codes
Control Panel Operations and Menus 2–7