Technical data

E.2 LJ2D Submenu
E.2 LJ2D Submenu
Figure E–2 shows the configuration and flow of the LJ2D protocol submenu.
See Figure 2–4 to see how this submenu connects to the Set Up menu diagram.
Use the following procedure to enter the LJ2D protocol menu:
1. Press
Online/Pause
to set the printer to paused mode.
2. Press
Set Up
to display the PROTOCOL text.
3. Press to display the selected protocol. DEC PPL3 is factory default.
4. Press
>
to select LJ2D protocol.
5. Press to enter the selection. An asterisk (*) will appear.
6. If you wish the LJ2D protocol to remain invoked through power on/off
cycles, make sure to save the user defaults, as shown in Section 2.5.
To exit from the Set Up menu, press
Online/Pause
once or as many times
as necessary.
E–8 Resident Protocols