Technical data

A
Supplemental Information
This appendix contains general information that you may find useful.
A.1 Interface Interconnections
The DEClaser 3200 printer can connect to a host system through the 8-bit
parallel bus or through the serial port. You select a port through the COM
INTERFACE feature of the Set Up menu, as shown in Figure 2–4.
A.1.1 Parallel Port
The parallel port uses a Centronics interface protocol and a 36-pin connector.
Figure A–1 shows the shape, pin configuration, and a signal diagram of the
parallel port. Table A–1 gives the pin numbers and signal names.
Figure A–1 Parallel Port Connector
18 1
36 19
MLO-004886
Pin Assignment
(continued on next page)
Supplemental Information A–1