Technical data

10.5 Feed Roller Cleaning Procedure
Step Description or Note
8. Press
Test
Enter the Test menu. See Section 2.6 for additional
information. CONFIG SHEET will appear on the
display.
9. Remove the cassette
from the selected slot.
Do the following:
1. Remove the paper.
2. Install the cleaning tool in the cassette so the fur
pad will contact the feed rollers.
3. Open two packages and remove the alcohol
towelettes.
4. Wring the alcohol out of both towelettes onto both
fur pads.
10. Insert the cassette and
cleaning tool
Into the slot that was selected in step 6 above.
11. Press To print the CONFIG SHEET.
Depending on which slot was selected, in step 6 above,
one of the following messages will appear:
• CLEAR PAPER PATH 0821
• CLEAR PAPER PATH 0822
12. Remove the cassette and
cleaning tool
From the selected slot.
13. Power down the printer Repeat the procedure to clean the other feed rollers.
10–6 Adjustments and Cleaning Procedures