Technical data

10.3 Horizontal Registration Adjustment
10.3 Horizontal Registration Adjustment
The horizontal registration fixes the image between the rear and front of the
printer. The horizontal registration is perfect when the width of the the rear
and front boarders are identical. Use the following procedure to enter, change,
and exit the Horizontal Registration set menu:
1. Press and hold
Defaults
and
>
while powering up the printer.
2. When you see four zeros (0000), press the menu mode keys to set the 1701
code and press once to enter it, as shown in Table 3–1.
3. Press the menu mode keys to set the 0282 code and press to enter it.
4. Press the menu mode keys to set 0282.01 code.
5. Press to enter the code. The current setting, or default, is displayed.
The following example demonstrates the Horizontal Registration set menu
format:
$05: 0.5mm
$ A dollar sign acts as a prompt.
05 This is the two digit hexadecimal set code. The higher order digit (0) is
always zero and it cannot be altered. The lower order digit (5) changes
the offset display by ±0.5mm increments per digit.
: A colon separates the set code from the offset display.
The arrow indicates the direction of image offset from the center of the
sheet. Left is towards the front of the printer, right is towards the rear
of the printer.
0.5mm The amount of offset shift for the accompanying set code. The following
settings are available:
$00: 2.0mm $05: 0.5mm
$01: 1.5mm $06: 1.0mm
$02: 1.0mm $07: 1.5mm
$03: 0.5mm $08: 2.0mm
$04: 0:0mm Recommended factory default setting.
6. Press and to change the lower order set code.
7. Press to enter the new position.
8. Press
>
and
Defaults
to exit from the Horizontal Registration set menu.
The four zeros (0000) will reappear.
9. Power the printer off, then on to return to online operation.
Adjustments and Cleaning Procedures 10–3