Technical data

10.1 Setting Auto Scan
9. Power the printer off, then on to return to online operation.
10.2 Setting Power Saver Time
The fuser power saver timer is adjustable between 0 and 7650 seconds in
30 second increments. If no printing is performed and the timer zeros out,
the printer enters the Power Saver mode and displays the message POWER
SAVER ON.
In the Power Saver mode, fuser power shuts off and fuser cools to room
temperature. When a print job is received, the message POWER SAVER OFF
is displayed for the minute or so of warm up time.
1. Press and hold
Defaults
and
>
while powering up the printer.
2. When you see four zeros (0000), press the menu mode keys to set the 1701
code and press once to enter it, as shown in Table 3–1.
3. Press the menu mode keys to set the 0282 code and press to enter it.
4. Press the menu mode keys to set the 0282.90 code.
5. Press to enter the code. The current setting, or default, is displayed.
The following example demonstrates the power saver format:
$57 : 2730
$ A dollar sign acts as a prompt.
57 The two digit hexadecimal set code. The higher order digit (5) changes the
the time by ±480 second increments from a start of 600. The lower order
digit (7) changes the time by ±30 second increments from a start of 150.
When set to zero (00) the time is forced to 7680.
: A colon separates the set code from the offset display.
2730 The time display is the time in seconds approximately 45.5 minutes. The
recommended setting is $FF: 7680 or 00 : 7680
6. Press the menu mode keys to change the set code and alter the power
saver time display.
7. Press to enter the new power saver time.
8. Press
>
and
Defaults
to exit from the power saver time set menu. The
four zeros (0000) will reappear.
9. Power the printer off, then on to return to online operation.
10–2 Adjustments and Cleaning Procedures