Technical data

6.3 0826 CLEAR PAPER PATH
2. Test the refeed sensor circuit by entering the 1701 Test code 0813. The
SENSING display will appear. When you actuate the sensor, the beeper
sounds and control panel lights up. Do the following if the test fails:
a. Inspect the 3-pin plug that connects the refeed sensor to the connector
in the exit chassis.
b. Inspect the 20-pin plug that connects P/J56 on the driver board to
P/J47 on the DC control board.
c. Swap the following:
• Refeed sensor
• Driver board
• DC control board.
3. Test the reverse operation of the exit rollers by entering the 1701 Test code
1102. If the test fails, do the following:
a. Inspect the 20-pin plug that connects P/J56 on the driver board to
P/J47 on the DC control board.
b. Inspect the 6-pin plug connecting the exit motor to P/J54 on the driver
board.
c. Swap the following:
• DC control board.
• Driver board.
• Exit motor.
Paper Path Jam FIPs 6–17