Technical data

5.20 1001–1005 CALL SERVICE
Warning: Turn off the ac power before performing the next step.
1. Refer to Figure 5–15, while you inspect the following:
• 2-pin plug that connects to P10 of the LVPSA
• 2-pin plug that connects the thermistor to the wire harness at the front
of the printer.
• P56 that connects the wire harness to the driver board
• P/J47 that connects the wire harness to the DC control board
• 14-pin cable that connects P/J31 of the DC control board to P/J14 of the
LVPSA.
2. Swap the following FRUs:
• Fuser unit
• DC control board
• LVPSA
Display Error Code FIPs 5–29