Specifications
The ULTRIX Operating System, Version 4.5 SPD 26.40.32
Processor
DECsystem 5810
DECsystem 5820
DECsystem 5830
DECsystem 5840
VAX 6000-210
VAX 6000-220
VAX 6000-230
VAX 6000-240
VAXserver 6000-210
VAXserver 6000-220
VAX 6000-310
VAX 6000-320
VAX 6000-330
VAX 6000-340
VAX 6000-350
VAX 6000-360
VAXserver 6000-310
VAXserver 6000-320
VAX 6000-410
VAX 6000-420
VAX 6000-430
VAX 6000-440
VAX 6000-450
VAX 6000-460
VAXserver 6000-410
VAXserver 6000-420
Rainbow 100B
Rainbow 100+
Rainbow 190
Rainbow 100B
Rainbow 100+
Rainbow 190
Rainbow 100B
Rainbow 100+
Rainbow 190
Rainbow 100B
Rainbow 100+
Rainbow 190
PRO 350/380 PRO 350/380 PRO 350/380 PRO 350/380
VAXmate VAXmate VAXmate VAXmate
Notes:
1
Letter D = Data device only.
Letter L = Valid ULTRIX load device.
2
The asynchronous and the general purpose parallel interfaces as a printer port in DMA mode of the DMB32 are supported.
3
The KDB50 must be at microcode Revision Level K or greater.
4
A maximum of one UNIBUS tape controller per UBA.
5
Either one DELUA or one DEUNA controller can be configured on any UNIBUS adapter. VAX 8700 and VAX 8800 systems
can have two UNIBUS adapters. All other systems are limited to one UNIBUS adapter. The maximum number of Ethernet
adapters includes both BI and UNIBUS devices. LAT and DECnet traffic is restricted to one Ethernet. Each Ethernet must be
connected to a separate network or subnetwork in a routing configuration.
6
A maximum of one CI interface per system is supported.
7
The DEBNI is a high-speed BI-to-Ethernet adapter intended as a replacement for the existing DEBNA. The DEBNI is available
as either a new module or firmware upgrade option to an existing DEBNA.
8
The TA90 must be connected to an HSC running V3.90A or later.
9
The TA90E must be connected to an HSC running V5.0 or later.
10
The TA91 must be connected to an HSC running V4.0 or later.
11
The TA91 is supported in KDM70 Software V3.0.
12
The CIXCD must be at revision 2.2 or higher.
13
Supported configurations are:
VAX 6000-410 with 1 attached vector processor
VAX 6000-420 with 1 attached vector processor
VAX 6000-420 with 2 attached vector processors
14
DEClaser support is equivalent to that which is available for the LN03, LN03R, and LN03S printers.
15
HSC40, HSC50, HSC70, HSC90 only.
16
Accepts TK50 distribution media.
17
Automatic stack loader tape drives are supported only by the dump, restore and cpio system utilities.
34