Specifications

The ULTRIX Operating System, Version 4.5 SPD 26.40.32
Processor VAX–11/750
VAX–11/780
VAX–11/785
VT420 VT420
DECmate II/III DECmate II/III
Rainbow 100B
Rainbow 100+
Rainbow 190
Rainbow 100B
Rainbow 100+
Rainbow 190
PRO 350/380 PRO 350/380
VAXmate VAXmate
Notes:
1
Letter D = Data device only.
Letter L = Valid ULTRIX load device.
2
The asynchronous and the general purpose parallel interfaces as a printer port in DMA mode of the DMF32 are supported.
3
The DMR11 is supported using TCP/IP and DECnet over full- and half-duplex point-to-point DDCMP sync lines. DMC mode
is used for backwards compatibility.
4
The TU58 console tape on the VAX–11/750 is supported in single-user mode only.
5
The UDA50 must be at microcode Revision Level 4 or higher.
6
Each UDA50 must be configured on a separate UNIBUS adapter.
7
A maximum of one UNIBUS tape controller per UBA.
8
The TU58-XB must be at minimum Rev K or F2 for the VAX–11/750.
9
The DF126 can only be used with the DUP11 device (IBM 2780/3780 emulation); maximum baud rate 2400.
10
The DUP11 can only be used in conjunction with 2780/3780 terminal emulation.
11
Either one DELUA or one DEUNA controller can be configured on any UNIBUS adapter. LAT and DECnet traffic is restricted
to one Ethernet. Each Ethernet must be connected to a separate network or subnetwork in a routing configuration.
12
The HSC must be running V370 microcode or higher. A maximum of four are supported. HSC40, HSC50, HSC70 and
HSC90 only.
13
DEClaser support is equivalent to that which is available for the LN03, LN03R, and LN03S printers.
14
Accepts TK50 distribution media.
30