User guide

Maintenance
• Pressing down the ink slide (labeled <PUSH>) (1), move it slowly from
right to left along the full length of its shaft (2). Release the slide and return
it to the right edge (3).
1
23
Priming the print head
•
Repeat the operation until ink appears in the tube below the slide.
• Press Install Cartridge to move the print head carriage to the head loading
position, and repeat the above operation to empty the tube.
• Press Install Cartridge to return the print head carriage to its rest position.
• Close the top cover
• Press On-Line to return the printer to ON LINE condition.
If priming the print head does not result in improved print quality, switch the
printer off and then on again, and prime the print head again.
WARNING: Priming MUST NOT be repeated systematically, as it will
damage the print head. For used print heads, it should ONLY be attempted
as a last resort, before changing the ENTIRE print head.
4-10