User guide

Getting Started
NOTE: To remove the print head, see the "Changing the Print Head" section in
the Chapter 4 "Maintenance".
Running the Printer Self Test
Before running the printer test, please check the following:
- Printer is switched off
- Paper is loaded in the tray
- Paper securing lever (A) is in the Lock position (upper position)
- Print head is properly installed
To start the printer self test:
• Hold down the Install Cartridge button on the operator panel, while you
switch on the printer.
• Keep holding down the Install Cartridge button until the printer begins
printing.
- With a monochrome (black ink) print head, the automatic print test
produces 4 test sheets.
- With a color print head, a single test sheet is produced.
If there is no paper in the printer, the On-Line indicator will flash slowly. You
must load paper in the paper input tray and then press the Form Feed button.
To suspend the print test temporarily:
• Press the On-Line button (pressing this button a second time will cause
printing to resume).
To abandon the print test:
• You must switch the printer off.
2-15