User guide

Getting Started
Switching On the Printer
After checking ALL the previous points, and ONLY if no further intervention
is required, plug into the power outlet socket and switch on the printer (the On
indicator lights).
Switching on the printer
Whenever the printer is switched on:
- It undergoes a series of internal checks.
- It any faults are found, the On-Line indicator on the operator panel will
flash rapidly. Should this happen, switch the printer off and then on again. If
the fault persists, call your dealer or the technical assistance service.
- A mechanical reset is executed and the switches selectors are read. The print
head carriage stops in the extreme right-hand position (rest position).
- If no faults are found, the printer will be in ON LINE condition (On and
On-Line indicators lit).
• Switch off the printer.
NOTE: If you have had any problems, check that you have executed correctly
all the procedures described in this section; if you have, see the Chapter 5
"Troubleshooting".
2-11