User guide

Printer Controlling
Printer Programming within DOS Environment
This section explains how to change the printer settings either using the selector
switches on the covered shaft in front of the print head carriage or by varying
the values given in the Printer Driver. Programming the printer with the
selector switches is absolutely necessary to control your printer features within
DOS environment.
NOTE: The Windows Driver settings overwrite the corresponding selector
switches settings.
Factory Settings
When you receive the printer, its basic operating features are already set with
pre-defined values (default values). These factory settings will probably meet
your requirements. If they do not, you can change them, using the Set-Up
procedure.
NOTE: Always switch off the printer before changing the positions of the
selector switches, as their position is read only at printer switch-on.
The following table provides the factory settings determined by all the selector
switches in the OFF position, with the exception of the Paper Size selector
switches, which are explained later in this chapter.
C-10