Technical data

To make this change to the queue permanent, specify this form in the

execution queue deﬁnition in the DCPS$STARTUP.COM ﬁle.

7.8 Specifying Printer Resolution with Setup Module

These setup modules allow you to manipulate the resolution of PostScript

Level 2 printers.

Table 7–1 Printer Resolution Setup Modules

Setup Module Description

RES_300X300 300 dpi horizontal and vertical

RES_600X300 600 dpi horizontal and 300 dpi vertical

RES_600X600 600 dpi horizontal and vertical - default

RES_1200X600 1200 dpi horizontal and 600 dpi vertical

RES_1200X1200 1200 dpi horizontal and vertical

Note

Not all resolutions are supported by all printers. To have the printer

notify you if it cannot print at a speciﬁed resolution, add the /NOTIFY

switch to the PRINT command. If the printer cannot print at the

requested resolution, it prints at a lower resolution.

7.9 Modifying DECimage Parameters with Setup Modules

There following setup modules invoke DECimage or modify the DECimage

parameters. They are grouped into the following categories:

Enabling and Disabling DECimage

These setup modules leave all current parameters intact, and turn DECimage

on or off. It is not necessary to use these modules if you use other DECimage

setup modules. The DECimage setup modules automatically invoke DECimage

for the current print job.

Creating Setup Modules and Device Control Libraries 7–11