Technical data

3. Queue defaults specified for the execution queue
4. Defaults built into the DCPS software:
DATA_TYPE=AUTOMATIC
INPUT_TRAY=printer-specific
1
LAYUP_DEFINITION=no default layup definition
MESSAGES=NOMESSAGES
NUMBER_UP=0
OUTPUT_TRAY=printer-specific
1
PAGE_LIMIT=no limit
PAGE_ORIENTATION=PORTRAIT
PAGE_SIZE=(same as SHEET_SIZE)
SHEET_COUNT=1
SHEET_SIZE=printer-specific
1
SIDES=printer-specific
1
TAB=NOTAB
Some parameter values are controlled by the printer hardware and can be
set through means other than the DECprint Supervisor software. DIGITAL
PrintServer printers are affected by the PrintServer Software. Other printers
are controlled through the printer control panel or switches.
3.3.5 Supplying Default Queue Attributes (P5)
You can supply a value to override or add to the default queue attributes. Do
not use the INITIALIZE/QUEUE command to set these qualifiers. Enter them
into the queue definition instead.
By default, the printer startup command procedure creates print queues with
the following INITIALIZE/QUEUE qualifier settings:
• /SEPARATE=(BURST,TRAILER,NORESET)
The /SEPARATE qualifier is used to specify job separation pages. The
default setting specifies:
Job burst pages.
Job trailer pages.
No reset module is sent between print jobs (NORESET). This setting is
included for compatibility with sites upgrading from PrintServer client
software.
• /FORM_MOUNTED=DCPS$DEFAULT
1
These settings depend on the setting of the printer’s PostScript interpreter.
3–8 Creating and Modifying Print Queues