Technical data

Table A–2 SET PRINTER Qualifier Equivalents for DECprint Supervisor
Queues
SET PRINTER
Qualifier Equivalent Control
/CR Insertion of carriage return characters is controlled by the
current data type translator.
/FALLBACK Translation of DIGITAL multinational characters is controlled by
the current font. If the character does not exist in the specified
font, the font error character prints.
/FF Mechanical form feeds are controlled by the current data type
translator or the PostScript interpreter.
/LOWERCASE The DECprint Supervisor printer is considered to be a lowercase
printer. It does not translate lowercase to uppercase.
/PAGE The number of lines printed on each page is controlled by the
ANSI translator (ANSI files only). This characteristic is available
through DEFINE /FORM.
/PASSALL Whether the system interprets special characters or forwards
them as 8-bit binary data is controlled by the current data type
translator.
/PRINTALL Whether the printer interprets special characters or prints their
8-bit binary equivalent is controlled by the current data type
translator.
/TRUNCATE Truncation of data that exceeds the limitation imposed by the
/WIDTH qualifier is controlled by the form definition or the
current data type translator.
/WIDTH The number of characters allowed on each line of the currently
installed media is controlled by the form definition, or a
combination of the current data type translator and the current
font.
/WRAP Generation of a carriage-return/line-feed by the printer when it
reaches the end of a line is controlled by the form definition or
the current data type translator.
A–4 Printing System Management Commands