Technical data

You can use the service circuit name and the Ethernet address to make a
connection to the LAT node using the following command:
$ MCR NCP
NCP> CONNECT VIA service-circuit PHYSICAL ADDRESS nn-nn-nn-nn-nn-nn
After entering the NCP CONNECT command, press Return until you get the
pound sign (#) prompt. At this prompt type the password (ACCESS) to get the
Local> prompt:
#
username: username
Local>
Step 4B: At the LAT console port
After making your connection and logging in to the LAT console, enter the
following commands:
Local> SET PRIVILEGED
Password>
Local> SHOW SESSIONS PORT_7
The default password is SYSTEM.
The following example shows a SHOW SESSIONS PORT command on a
DECserver 200 that tells you that a remote system HAILEY controls port 7.
Local> SHOW SESSIONS PORT 7
Port 7: (Remote) Connected Current Session 1
-Session 1: Hailey Connected Pasthru
If your system runs the TSM software, issue the following commands:
$ RUN SYS$SYSTEM:TSM$MAIN
TSM> USE SERVER tas204
TSM> SET PRIVILEGED
Password>
TSM> SHOW SESSIONS PORT_7
Note
To run the TSM program, you need read access to the TSM
management directory file and OPER privileges. For more information,
refer to the Guide to Terminal Server Manager.
11–10 Troubleshooting Procedures