Technical data

10.11.2 First Job May Be Offset Incorrectly
The first DCPS job to print to the LN40 after the printer is powered on may
jog incorrectly. This occurs only if the LN40 is configured with OFFSET
STACKING set to ON and COLLATION set to OFF.
10.12 Compaq and DIGITAL Laser Printer LNC02
10.12.1 Minimum Firmware Version
To use the LNC02 with the Raw TCP/IP protocol from DCPS, the printer must
be running a minimum firmware version of System Release 1.1.1, Revision 3.11.
This firmware version number is displayed on the printer’s startup page.
10.12.2 Incorrect Sheet Count
The sheet count reported on the job trailer page and in the OpenVMS
accounting file is incorrect due to a limitation with the LNC02 printer. There
is no known workaround. The LNC02 has, however, an accounting feature that
can be used to track printer utilization.
10.13 DIGITAL PrintServer 17 Printer
10.13.1 Colored Separator Pages and Tray Switching
PrintServer Software, Version 5.0, adds input tray failover to the PrintServer
17 series printers. This feature allows the printer to automatically switch
to another input tray containing the same size media when the current tray
becomes empty. This feature is enabled by default.
If you currently use colored flag pages, you may want to disable this feature.
To disable input tray failover, perform the following steps:
1. Edit LPS$SUPPORT:LPSDEFAULTS.<printer name>
2. Search for the /TraySwitch parameter:
/TraySwitch true % Controls input tray failover.
% false = disable
% true = enable
3. Change the value of the TraySwitch parameter from ‘‘true’’ to ‘‘false’’.
PostScript is case sensitive; the only valid values are ‘‘true’’ or ‘‘false’’.
/TraySwitch false % Controls input tray failover.
% false = disable
% true = enable
10–10 Printer-Specific Information