Technical data

10.7.3 Downloading and Deleting Fonts
You may download or delete fonts from the DEClaser 5100 printer’s optional
hard drive using the FONT_DOWNLOADER.COM procedure described in
Appendix C.
10.7.4 Error Page Feature
The DEClaser 5100 printer has a feature that ejects the current sheet and then
prints a PostScript Error information sheet when a PostScript interpreter error
occurs. While this feature provides a powerful means for analyzing PostScript
problems, it is not recommended for everyday use with the DCPS software for
the following reasons:
• PostScript error pages are printed when a user enters
DELETE/ENTRY to
abort a print job.
• PostScript error pages are printed after a not ready condition is cleared
(paper supplied, jam corrected, etc.) if a job was submitted on the serial
port while the printer was not ready to print.
You should disable the feature called ‘‘Print Errors’’ through the DEClaser
5100 front panel before starting print queues with DCPS. Enable the feature
only when you are interested in analyzing PostScript problems.
If a job fails to print because of a ‘‘Limitcheck’’ error, also see if ‘‘page protection
required’’ is part of the error message. Presence of this error means the job
failed because of a banding failure.
10.8 DIGITAL Laser Printer LN15+
The DIGITAL Laser Printer LN15+ is an upgrade to the DIGITAL Laser
Printer LN15. References in the DCPS documentation to the DIGITAL Laser
Printer LN15 also apply to the DIGITAL Laser Printer LN15+.
10.8.1 Printer Configuration Settings
DCPS requires certain LN15 printer characteristics to be set. If these values,
described in Table 10–2, are not set, DCPS jobs will remain in a Starting state
and never print.
Printer-Specific Information 10–7