Technical data

10.3.4 Queue Aborts When Using TCPware
When using TCPware with these printers, it is possible to receive numerous
userdata messages on the screen and have the queue fail with an OPCOM
message similar to the following:
%%%%%%%%%%% OPCOM 21-APR-1999 15:09:53.22 %%%%%%%%%%%
Message from user SYSTEM on ZIPPY
Queue LN32_RAW: %DCPS-F-EXQUOTA, process quota exceeded
This problem occurs when running TCPware V5.3-3 and network firmware
V1.0/4 (990323). To avoid this problem, the system manager should perform
one of the following steps:
• Issue the following TCPware commands:
$ NETCU STOP /TCP
$ NETCU START /TCP /NOPATH_MTU_DISCOVERY
• Upgrade TCPware to a version later than V5.3-3
• Apply TCPware patch kit DRIVERS_V533P020
• Upgrade the printer’s network firmware
10.4 DIGITAL Colorwriter LSR 2000 Printer
10.4.1 NIC Does Not Work with Raw TCP/IP
DCPS cannot communicate with the Colorwriter LSR 2000 NIC via a raw
TCP/IP connection because the NIC does not support raw TCP/IP
communication.
AppleTalk is the only network protocol that DCPS can use to communicate
with the Colorwriter LSR 2000 printer.
10.5 DIGITAL DECcolorwriter 1000 Printer
10.5.1 Printer-Specific Setup Files
You can use the files listed in the table below to alter the persistent state of the
printer, affecting all subsequent jobs that the printer receives from your system
and from other systems in the network until the printer is turned off and back
on. The files are located in the SYS$COMMON:[SYSHLP.EXAMPLES.DCPS]
directory.
10–4 Printer-Specific Information