Technical data

10.3.1 Printer and Network Firmware Versions

Firmware versions are listed on the printed Summary Sheet and on the

printer’s internal Web page. Printer ﬁrmware is listed as Product Version and

network ﬁrmware is listed as Network Version.

10.3.2 Printer Conﬁguration Settings

10.3.2.1 Language-Sensing Mode

DCPS can print to these printers when the printer is in PostScript mode

or automatic language-sensing mode. Make sure the INTERPRETER and

FORMAT settings are set as described in Table 10–1. These values are set in

the INTERFACE menu on the printer’s console.

Table 10–1 Valid LN21, LN28, LN32, LNM40, mL210, mL280, mL320 and

mL401 Language Sensing Conﬁgurations

Printer Settings

Printer Mode Interpreter Format

PostScript/PCL sensing Auto Switch Raw

PostScript PostScript Normal

10.3.2.2 Printer Setting May Cause Stalled Queues

The factory default value for the printer’s Delayed Output Close setting may

cause DCPS queues to stall. The default value is OFF and is intended to

improve performance by controlling how quickly the printer ends one job and

starts another. However, if you also print from environments other than DCPS,

this value may cause DCPS queues to stall. Therefore, if you also print from

multiple environments, set the value to ON. If you print only from DCPS, you

may leave the value of Delayed Output Close at OFF.

The setting for Delayed Output Close is found on the printer’s console as

DELAY OUT CLOSE in the NETWORK section of the INTERFACE menu.

10.3.3 LAT and AppleTalk Conﬁguration

Please see Section 10.2.2 for information about conﬁguring LAT and AppleTalk

queues.

This setting does not appear on LN32 and LNM40 printers with ﬁrmware earlier

than version 3.03.

Printer-Speciﬁc Information 10–3