Service manual

Service Manual 9-13
Checks and Adjustments 9
7. Set DIP Switches 1-5, 1-6 and 1-7 to correspond to the desired top margin
adjustment. Positive numbers increase the distance the paper is inserted into
the paper clamp, thereby increasing the top margin. The bottom margin will
get correspondingly smaller. Conversely, negative numbers decrease the
distance the paper is inserted into the paper clamp.
8. Press the TEST button to store the new value into the printer's memory. The
MEDIA LED blinks when the value is stored. LEDs TRANSFER ROLL,
COVER, and READY blink to indicate the newly entered top margin value.
9. Set DIP Switch 1-3 off to stop the test.
10. Print a test print to check the margins and paper clamping.