Service manual

8-42 DECcolorwriter 1000

8 FRU Disassembly/Assembly

I/O board

1. Power down the printer. Leave the power cord plugged in to provide a

ground path for static discharges. Remove the interface cables.

2. Remove the top-rear and rear cabinet panels. Refer to the earlier topic

“Printer cabinet panels” on page 8-3.

3. Remove the screws securing the I/O board to the card cage.

4. Disconnect the I/O board’s ribbon cable from the image processor board.

Remove the I/O board.

Reverse these steps to reinstall the I/O board and the image processor board.

Tools required

n #1 POSIDRIV® screwdriver

Figure 8-37 Removing the I/O board

I/O board