Service manual

Service Manual 8-35
FRU Disassembly/Assembly 8
Card cage and power supply
1. Power down the printer and remove the power cord. Disconnect all host
interface connectors.
2. Remove the rear and side cabinet panels. Refer to the earlier topic “Printer
cabinet panels” on page 8-3.
3. Disconnect all wiring harnesses from the card cage.
4. Disconnect the four screws securing the card cage to the print engine frame
(two screws each on the left and the right sides).
Tools required
n #1 POSIDRIV® screwdriver
Figure 8-31 Disconnecting the wiring harnesses and removing the
card cage
4
Card cage
4
3
8699-43