Service manual

8-34 DECcolorwriter 1000
8 FRU Disassembly/Assembly
1. Power down the printer and remove the power cord.
2. Open the top access cover and remove the transfer roll.
3. Remove the drum as detailed in the earlier procedure “Drum” on page 8-19.
4. Disconnect the paper clamp sensor's wiring harness.
5. Remove the two screws securing the paper clamp sensor in place.
Reverse these steps to reinstall the paper clamp sensor. Run the calibration check
“Calibrating the paper clamp sensor (reflective sensor)” on page 9-10 to ensure the
sensor is properly adjusted
Figure 8-30 Removing the paper clamp sensor
8699-53
Paper clamp
sensor
4
5