Service manual

8-32 DECcolorwriter 1000
8 FRU Disassembly/Assembly
6. Tray sensor circuit board: Disconnect the tray sensors’ wiring harness.
7. Straighten the two metal tabs securing the tray sensors’ bracket to the
paper-feed module. Unhinge the bracket to access the tray sensor circuit
board.
8. Remove the screw securing the paper tray sensor circuit board to the bracket.
Remove the circuit board.
Reverse these steps to reinstall paper-pass sensor 2 and the tray sensor circuit board.
Figure 8-28 Removing the tray sensors circuit board
8699-51
Unhinge
here
Tray sensors
bracket
7
Tray sensors
circuit board
6
8