Service manual

8-26 DECcolorwriter 1000
8 FRU Disassembly/Assembly
5. On the outside of the printer, disconnect the wiring harness leading to the
transfer roll take-up motor.
6. Remove the two screws securing the transfer roll take-up motor to the print
engine frame. Remove the motor.
Reverse these steps to reinstall the transfer roll take-up motor. When you install the
take-up gear, be sure to position the gear's set screw over the keyed portion of the motor
shaft.
Figure 8-23 Removing the transfer roll take-up motor
6
5
Transfer roll
take-up motor
8699-48