Service manual

Service Manual 8-25
FRU Disassembly/Assembly 8
Transfer roll take-up motor
1. Power down the printer and remove the power cord.
2. Open the top access cover and remove the transfer roll.
3. Remove the left side cabinet panel. Refer to the earlier topic “Printer cabinet
panels” on page 8-3.
4. On the inside of the printer, loosen the transfer roll take-up gear's two set
screws. Remove the gear.
Tools required
n #1 POSIDRIV® screwdriver
Figure 8-22 Removing the transfer roll take-up gear
Gear,
reverse side
8699-47
Transfer roll
take-up
gear
4