Service manual

8-16 DECcolorwriter 1000

8 FRU Disassembly/Assembly

Bail roller assembly

1. Power down the printer and remove the power cord. Open the top access

cover and remove the transfer roll.

2. Remove the left and right side cabinet panels. Refer to the earlier topic

“Printer cabinet panels” on page 8-3.

3. Remove the four screws securing the bail roller assembly (two at each end:

one inside the frame and one outside) to the print engine frame.

4. Remove the bail roller assembly.

Reverse these steps to reinstall the bail roller.

Note Upon reassembly, make sure that the bail roller assembly metal frame

does not contact the drum’s paper clamp.

Tools required

#1 POSIDRIV® screwdriver

Figure 8-14 Removing the bail roller assembly

8699-33

Bail roller

assembly