Service manual

Service Manual 8-11
FRU Disassembly/Assembly 8
Lower aligning roller, clutch, and paper-pass sensor 1 flag
You must remove the lower aligning roller and clutch prior to removing the paper-pass
sensor 1 flag. Removing the paper-pass sensor 1 flag is an optional step.
1. Remove the E-ring securing the aligning roller clutch. Remove the clutch.
(For reassembly, note the keyed shaft the clutch fitsþonto.)
2. Remove the two E-rings securing the lower aligning roller (black rubber) to
the upper half of the paper-feed module. Remove the lower aligning roller.
Be careful not to damage the paper-empty flag.
Figure 8-9 Removing the lower aligningþroller
2
8699-28
Washer
1
2
Aligning
roller 
clutch
Washer
Lower 
aligning
roller