Service manual

8-6 DECcolorwriter 1000
8 FRU Disassembly/Assembly
Accessing the pick roller, aligning roller, and the lower feed
roller
1. Power down the printer and remove the power cord.
2. Remove the paper-feed module as explained in the previous procedure
“Paper-feed module” on page 8-5.
3. Remove the two screws securing the paper-feed circuit board to the
paper-feed module. (One screw is reached through an access hole.) Slide the
board out of the way.
When you reinstall the paper-feed circuit board, be sure to engage the two solenoid gear
pawls with their respective clutches.
Figure 8-4 Removing the paper-feed circuit board
8699-24
Paper-feed
module
Paper-feed
circuit board
3