Service manual

Service Manual 8-5

FRU Disassembly/Assembly 8

Paper-feed module

1. Power down the printer and remove the power cord. Remove the paper tray.

2. Remove the front access cover. Also, remove the lower front cabinet panel

and the left and right side cabinet panels. Refer to the earlier topic “Printer

cabinet panels” on page 8-3.

3. Disconnect the paper-feed module wiring harnesses on the left side of the

printer.

4. Remove the two screws securing the paper-feed module to the printer frame.

Slide the module out.

Reverse this procedure to reinstall the paper-feed module.

Tools required

n #1 POSIDRIV® screwdriver

n Small flat-blade screwdriver

n Needle-nose pliers

Figure 8-3 Removing the paper-feed module

Feed roller

Upper

aligning

rollers

Paper-feed

module

8699-23