Service manual

8-10

Parts Replacement

Removing the Mechanical Assembly Front Structure

• Remove the mechanical assembly as explained in the corresponding section.

• Disconnect flat cables 1 and 2.

• Disconnect the ink discharge tube 3.

• Release the carriage motor cable from cable clip 4.

• Press catch 5 and partly lift the front structure 6.

• Press catches 7 and 8 to separate the front and rear structures.

• Remove bush 9.

NOTE: Before remounting the two structures back together again, insert the

carriage motor connector into the slot on the rear structure. Make sure rollers

10 are mounted correctly.

Fig. 8-9: Removing the mechanical assembly front structure

S-8BIS.PM5 11/7/94, 17:3510