Service manual

3-19

Installation

If the optional serial interface has been installed:

Baud Rate 2400

Parity None

Handshaking Hardware

Programmable Parameters

You can change the factory default settings using a total of seven selector

groups.

Programming the Parameters and Running Setup

• Power off the printer.

• Open the printer's top cover (1), then the selector switches cover (2).

Fig. 3-19: Programming Selectors

• Set the selectors according to the parameters given in the tables on next

pages.

• Power the printer back on again.

NOTE: The selectors are read during the printer's power on phase.

S-3.PM5 11/7/94, 17:1619