User`s manual

3.4 Software Configuration
AlphaPC64> bootopt nt
O/S type selected: "The Windows NT Operating System"
....Firmware type: "Windows NT Firmware"
AlphaPC64> bootopt
Predefined bootoptions are...
"0" "Alpha Evaluation Board Debug Monitor" "DBM"
"1" "The Windows NT Operating System" "NT"
"2" "OpenVMS" "VMS"
"3" "Digital UNIX" "UNIX"
O/S type selected: "The Windows NT Operating System"
....Firmware type: "Windows NT Firmware"
AlphaPC64>
(Support for other operating systems requires the purchase of the
proper software license.)
2. Turn off the power to the Alpha PCI 64–275. Verify the presence of a
jumper at J3-25/26 (see SP7 on the board).
3. Turn on the power to the Alpha PCI 64–275. After the power-up
diagnostics run (10–15 seconds), the ARC console boot menu appears
on the graphics display.
B. If you used item B in Section 3.4.2 to enter the debug monitor, then use
this procedure to return to Windows NT ARC firmware:
1. Turn off the power to the Alpha PCI 64–275 and install the jumper at
J3-25/26 (see SP7 on the board).
2. Turn on the power to the Alpha PCI 64–275. After the power-up
diagnostics are run, the ARC console boot menu appears on the
graphics display.
If the ARC console boot menu does not appear, check the output of
COM1 for error messages and review your hardware configuration.
Starting and Using the Alpha PCI 64–275 3–7