User guide

Table 3–2 (Cont.) Environment Variable Summary
Variable Description
D_EOP Specifies whether end-of-pass messages are to be displayed.
D_GROUP Specifies the diagnostic group to be executed.
D_HARDERR Defines the action that is to be taken following a hard error
detection.
D_OPER Specifies whether an operator is present.
D_PASSES Specifies the diagnostic pass count.
D_REPORT Specifies the level of information to be provided by diagnostic
error reports.
D_SOFTERR Defines the action that is to be taken following soft error
detection.
D_STARTUP Specifies whether a diagnostic startup message is to be
displayed.
D_TRACE Specifies whether trace messages are to be displayed.
DUMP_DEV Specifies that a device is to write operating system crash
dumps.
ENABLE_AUDIT Specifies whether audit trail messages are to be generated
during bootstrap.
EWA0_ARP_TRIES Specifies the number of transmissions to be attempted before
the Internet Address Resolution Protocol (ARP) fails.
EWA0_BOOTP_FILE Specifies a generic file name to be included in an Internet Boot
Protocol (BOOTP) request.
EWA0_BOOTP_
SERVER
Specifies a server name to be included in a BOOTP request.
EWA0_BOOTP_TRIES Specifies the number of transmissions that are to be
attempted before BOOTP fails.
EWA0_DEF_GINETADDR Specifies the initial value for EWA0_GINETADDR when
the interface’s internal Internet database is initialized from
BOOTP (EWA0_INET_INIT is set to BOOTP).
EWA0_DEF_INETADDR Specifies the initial value for EWA0_INETADDR when the
interface’s internal Internet database is initialized from
BOOTP (EWA0_INET_INIT is set to BOOTP).
EWA0_DEF_INETFILE Specifies the initial value for EWA0_INETFILE when the
interface’s internal Internet database is initialized from
BOOTP (EWA0_INET_INIT is set to BOOTP).
(continued on next page)
Operating the Digital Alpha VME 4 Computer 3–5