User guide

Figure 2–9 Connecting the SCSI Cable to the Primary Breakout Module
MLO-013241
10. Install the primary breakout module (refer to Figure 2–10). Ensure that the
breakout module is installed behind the slots occupied by the Digital Alpha
VME 4 module (as shown).
Caution
Running the Digital Alpha VME 4 module when it is not in the same slots
as the correct breakout module (refer to Figure 2–10) may damage your
backplane, the Digital Alpha VME 4 module, or both.
Never insert a module other than an Digital Alpha VME 4 module into a
slot opposite the breakout module. The breakout module feeds power to
several of the user-defined pins on the P2 backplane connector. This may
damage another VME module.
It is recommended that the slot number and type of breakout module be
recorded to ensure that the Digital Alpha VME 4 modules are always
installed into a slot with the appropriate breakout module.
2–18 Installation Procedures