User guide

Table 2–7 Supported Switch Settings for Digital Alpha VME 4 Modules in Other
Than Slot 1 (Nonsystem Controller)
Switch Setting
1 Closed
2 Open
3 Closed
1
4 Open
1
1
These switches are required to be in the indicated positions (one opened, one closed) for reliable
system operation during a VMEbus Reset.
3. Install the memory module on your Digital Alpha VME 4 module (Figure 2–4)
in the following manner:
• Populate bank 0 first, then bank 1, if necessary.
• Memory installed in a bank must be the same size and speed.
• Align pin 1 of the memory module with pin 1 on the connector. The
position of the orientation notches (see in Figure 2–4) assure proper
connectivity.
2–10 Installation Procedures